Vicks Humidifier V3500 User Manual

IMPORTANT!  
READ AND SAVE THESE INSTRUCTIONS  
®
Vicks Natural Mist Humidifier  
(Model V3500)  
Use and Care Manual  
If you have any questions about the operation of your Vicks Natural Mist Humidier, call our  
toll-free Consumer Service line at 800 477-0457  
k
Manufacturing Quality Healthcare Products for Over 75 Years  
 
®
Important Safety Instructions  
Vicks Natural Mist Humidifier  
READ ALL INSTRUCTIONS BEFORE  
USING HUMIDIFIER, ESPECIALLY THESE  
BASIC SAFETY PRECAUTIONS:  
1. Always place Humidier on a rm, flat, level surface, at least FIVE inches away from  
walls and heat sources such as stoves, radiators or heaters. Humidier may not work  
properly on a non-level surface.  
Tank Handle  
Water Tank  
2. When moving, or lifting the Humidier make sure you have a secure grip under the  
Base of unit. When removing the Tank, use one hand on the Tank Handle and the other  
on the bottom of the Tank on the Fill Cap. This will help prevent leakage of water or  
breakage of the unit itself.  
Fan Housing  
3. Place Humidier in an area that is out of the reach of children.  
4. Before using the Humidier, extend the cord and inspect for any signs of damage.  
Do not use the product if cord has been damaged.  
Switch Knob  
5. This product has a polarized plug (one blade is wider than the other) as a safety feature.  
This plug will t into a polarized outlet only one way. If the plug does not t fully into  
the outlet, reverse the plug. If it still does not t, contact a qualied electrician. Do not  
attempt to defeat this safety feature.  
Speed Selector  
Cap Gasket  
(Black O-Ring)  
WF2  
Wicking Filter  
6. Humidier should always be unplugged and emptied when not in operation or while  
being cleaned.  
7. Never tilt or move the Humidier while it is in operation. Shut off and unplug before  
moving.  
Fill Cap  
8. Humidier requires regular cleaning. Refer to and follow cleaning instructions.  
Base  
SAVE THESE INSTRUCTIONS  
 
®
Using Your Vicks Natural Mist Humidier  
Care and Cleaning  
Your Vicks Humidier comes fully assembled and ready to use.  
CAUTION: ALWAYS TURN OFF THE POWER SWITCH AND DISCONNECT THE POWER  
CORD FROM THE ELECTRICAL OUTLET BEFORE CLEANING.  
Humidiers provide comfort by adding moisture to dry indoor air. For maximized benet from  
your Vicks Natural Mist Humidier, follow instructions carefully. Please note that this is an  
electric appliance and requires careful attention when in use.  
First Time Use  
Read all instructions before using this appliance.  
Filling the Humidier  
Tap water may contain pollutants and minerals (scale) that can deposit on the inner surfaces  
of the Humidier and clog the Wicking Filter. Such scale can accelerate the growth of  
microorganisms and can impair the performance of the Filter.  
1. Unpack Humidier. Remove Fan Housing and check that the Wicking Filter is in place  
in Base. Replace Fan Housing, being careful to seat it properly onto the Base.  
2. Place Humidier at least FIVE inches away from walls and heat sources, on a FIRM,  
FLAT, LEVEL surface. Place on a water-resistant, non-conducting surface for protection  
from inadvertent spillage. Do not place any object over the Humidier; it could block  
air openings.  
Daily Maintenance  
1. Turn switch to off (O) position and unplug the cord from wall outlet.  
2. Remove Tank & Fan Housing and empty Base. Rinse Base and Tank, wipe clean, and dry  
with a clean cloth or paper towel. Be careful that you do not damage the delicate Wicking  
Filter. DO NOT immerse the Fan Housing or clean with water.  
3. Completely unravel power cord. Inspect power cord for signs of damage before use.  
If cord is damaged, DO NOT use product, please call 1-800-477-0457.  
3. Replace Fan Housing then the Tank. Humidier is now ready for use.  
Weekly MaintenanceRemoving Scale  
4. Keep cord away from heated surfaces and out of the way, where it cannot be stepped  
on or tripped over.  
5. Remove Tank using Tank Handle. Turn Tank over and carefully remove Fill Cap by turning  
Fill Cap counter clockwise. Fill the Tank with cool tap water. WARNING: Never use  
hot water - may cause damage to Wicking Filter.  
1. Empty any remaining water from the Base and Tank. Reassemble Humidier.  
2. Turn switch on and operate the Humidier without water until the Wicking Filter is  
thoroughly dry.  
6. Make sure the circular rubber Cap Gasket (O-Ring) is in place before replacing Fill Cap  
3. Turn switch to the OFF (O) position and unplug the cord from wall outlet.  
on Tank (this prevents water leakage). To tighten, turn Fill Cap clockwise.  
4. Remove Tank & Fan Housing and place on a flat surface. Remove the Wicking Filter from  
7. When carrying Tank always use two hands (one on Handle, one on the Fill Cap). Insert  
the Base by carefully lifting straight up, without bending or breaking or tearing the Filter.  
Tank back into Base.  
5. Fill Base with undiluted white vinegar. Let solution stand for 20 minutes.  
6. Dampen soft, clean cloth or sponge with undiluted white vinegar and wipe out Base  
to remove scale. DO NOT use soap, detergents or abrasive cleaners.  
Operating Instructions  
1. Fill the Water Tank and replace Tank on Base.  
7. Rinse thoroughly in clean warm water to remove scale and vinegar before disinfecting  
the Base.  
2. Make sure that switch is in OFF (O) position, place the unit on a flat, stable surface and  
Disinfecting Base  
plug cord into a 120 VAC wall outlet.  
1. Fill Base with 1 teaspoon of household bleach in 1 gallon of water. Let solution remain  
CAUTION: DO NOT PLUG IN THE CORD WITH WET HANDS; ELECTRIC  
SHOCK COULD RESULT.  
for 20 minutes, stirring every few minutes to ensure that all surfaces are coated.  
2. Empty Base after 20 minutes. Rinse with water until bleach smell is gone. Dry with clean  
3. Turn switch to either High or Low. Fan will start turning.  
cloth or paper towel.  
3. Wipe all exterior surfaces of the Fan Housing with a soft, dry cloth.  
DO NOT USE WATER TO CLEAN THE FAN HOUSING. AN ELECTRIC SHOCK  
MAY RESULT OR THE HUMIDIFIER MAY BE DAMAGED. DO NOT IMMERSE  
OR SPRAY ANY PART OF THE HUMIDIFIER WITH WATER.  
4. Replace the Wicking Filter into the Base, being careful not to damage the Filter.  
NOTE: Do not wash the Wicking Filter, since this will damage the Wicking Filter.  
 
Wicking Filter Maintenance  
Wicking Filter performance will diminish depending on the mineral content of the  
water and the amount of airborne dust in the environment.  
End of Season Maintenance or When  
Humidier Will Not Be In Use For  
At Least One Week  
IMPORTANT: CHECK WICKING FILTER REGULARLY. Any of the following conditions indicate  
1. Clean and dry the Humidier thoroughly as per the Weekly Maintenance instructions above.  
2. Let Humidier dry completely before storing. Do not store with water inside the Base.  
3. Remove Fill Cap. Do not store Humidier with Fill Cap on.  
that it is time to replace the Wicking Filter.  
A buildup of impurities and minerals on the Wicking Filter (evidenced by discoloration of  
the Wicking Filter)  
An appreciable decrease in Humidier output  
The top of the Wicking Filter is not moist to the touch  
The Wicking Filter has large holes or tears  
4. At end of season, remove and throw away the Wicking Filter. Never leave a used Wicking  
Filter in the Humidier during storage.  
5. Store in a cool dry location.  
6. Order your new Kaz Replacement Wicking Filter now, so that it will be available for use  
The Wicking Filter should be replaced at least one or two times during the season, depending  
on usage, mineral content of the water and the environment. We encourage you to only use a  
Kaz Model WF2 Replacement Wicking Filter. The use of other Wicking Filters may lead to  
substandard performance.  
next season.  
Trouble-Shooting  
If the unit does not operate:  
Replacement Filters  
WF2 Wicking Filters are generally available where you purchased your Humidier. If you are  
unable to locate replacement lters at your local retailer, they may be ordered directly from Kaz.  
Check that polarized plug is fully inserted into wall outlet.  
Check airflow. Are there any obstructions preventing airflow?  
WF2 Wicking Filters cost $10 for 2 Filters or $7 for 1 Filter plus $4 for  
handling and postage.  
The motor contains a temperature-limiting fuse. If the motor overheats, the fuse will trip  
and shut off the motor. Unplug the unit and contact our Consumer Service Department.  
Do not attempt to repair the motor yourself.  
NOTE: Prices are subject to change without notice.  
If you do not obtain enough humidity:  
To Order:  
The moisture output from an evaporative Humidier is invisible. It is operating properly  
if water level goes down during usage, even when you cannot see the vapor.  
By Phone  
Check the Wicking Filter. Replace the Filter if it is clogged, torn or discolored.  
Call toll-free by dialing 1-800-477-0457. Please have your credit card handy for payment. We  
accept Visa and Master Card. Minimum credit card order is $10.00.  
Check the water level. Relling may be required.  
If you are obtaining too much humidity:  
By Fax  
If room air is excessively humid (greater than 50% relative humidity), do not use the  
Humidier. Excessive humidity is indicated by condensation on cold surfaces or walls in  
the room. For proper humidity readings, use a hygrometer available in most hardware  
and department stores.  
Fax your order to Kaz Consumer Service Orders at 1-518-828-2015. Please clearly print your  
name, mailing address and products ordered. Be sure to specify Visa or Master Card, card  
number and expiration date, and sign your order. Minimum credit card order is $10.00.  
By Mail  
If water leakage occurs:  
Mail your order to Kaz Consumer Service Orders, One Vapor Trail, Hudson, NY 12534. Please  
clearly print your name, mailing address, and products ordered. Enclose check or money order  
(no cash, please).  
Make sure unit is unplugged from wall outlet.  
Remove Tank from Base and check Fill Cap. Make sure the Cap Gasket (O-Ring) is  
properly positioned in the cap and the spring valve operates freely. If leakage still  
occurs contact our Consumer Service Department.  
Via The Internet  
E-mail us at consumerservice@kaz.com. Be sure to include your name, mailing address and  
products ordered. Please specify Visa or Master Card, card number and expiration date.  
Minimum credit card order is $10.00.  
If Fill Cap is too tight:  
Lightly lubricate the Cap Gasket (O-Ring) with petroleum jelly.  
 

TDK Network Card iQM Series User Manual
Technicolor Thomson Video Game Controller LCP 400 User Manual
The Singing Machine CD Player SMG 180 User Manual
Toastmaster Toaster TMT4 User Manual
Toshiba Cash Register MA 1900 User Manual
Toshiba Projector TLP XE30 User Manual
Transition Networks TV Converter Box J E CX TBT 01 User Manual
Tricity Bendix Oven BS 613 2 User Manual
Viper Exercise Bike Viper 315 00109 User Manual
Weber Thermometer Digital Pocket Thermometer User Manual